Scissor lift designed for wheel alignment of vehicles up to 5500 kg.
Solid and aesthetically manufactured scissor lift, designed to work with devices for wheel alignment of vehicles weighing up to 5500 kg. Precise machining using laser cutting and robotic welding, as well as moving parts made of special materials, ensure a long lifetime of the lift, thus reducing service and maintenance costs.
The lift is equipped with recesses for the turntables, together with a set of turntables, rear suspension loosening plates, and a pneumatic, sliding axle jack, with a lifting capacity of 3000 kg. The hydraulic drive of the lift allows for comfortable and economical operation, the time of full lifting does not exceed 55 seconds, and lowering, after releasing the safety latches, is carried out without the use of electricity. In addition, the lift is equipped with LED workplace lighting, and a wired remote control, allowing you to raise and lower the lift from anywhere.
Thanks to the double lock safety system, emergency lowering system in the event of a power failure, and safe lowering with a warning signal, the MM Superfilt 5000 SC has a very high level of safety.
There are two ways to install a lift:
- installation on the floor - in this case it is necessary to equip the lift with accessory run-up ramps (007935018215)
- installation in the foundation recess - thanks to such installation, we obtain a flat surface relative to the floor level in the service, which ensures high comfort of work and maximum lift functionality
Load capacity 5500 kg
Lifting height 1850 mm
The minimum ramp height (for mounting on the floor) 380 mm
Ramp length 5000 mm
Ramp width 670 mm
Lifting time ≤55 s
Lowering time ≤55 s
The length of the entire lift 5500 mm
The width of the entire lift 2140 ~ 2240 mm
Pneumatic axle jack capacity 3000 kg
The lift is delivered in 5 packages with weights and dimensions as below